Branch shredder

The branch shredder is also called a wood shredder, which integrates slicing and crushing. It can cut branches and branches with a diameter of 1-20 cm. It is mainly used for processing pine, miscellaneous wood, poplar, fir, raw bamboo and other materials. It is more suitable for Machining of wood chips in edible mushroom culture. At the same time, the equipment can also be used for cutting chips of fibrous stalk-like materials such as bamboo, thatch, corn stalk, and sorghum stalk. As the name suggests, wood shredder is to smash wood; wood shredder has the characteristics of compact and reasonable structure, easy operation, high production capacity and convenient feeding.

Use safety precautions of Branch shredder:

1. Persons under the age of 16 are strictly prohibited from operating this machine.
2. In order to ensure the safety and normal work of the person and the machine, a special person should be designated to be responsible for the storage and use. Before learning this regulation and operating technology, do not operate the machine at will.
3. Check whether the screws at the joint are loose, especially the screws between the blade and the fixed knife. Pay more attention. If there is any looseness, tighten it immediately.
4. It is strictly forbidden to remove the feeding bucket and feed it directly
5. When replacing the fixed and movable knives and sieves, ordinary fasteners shall not be used instead.
6. When feeding the material, it should be uniform, and it should not be too much, so as to avoid the phenomenon of boring car.
7. The motor should be selected according to the provisions of the nameplate of the kneading machine. It is not allowed to increase the spindle speed at will, and it is not allowed to arbitrarily remove the protective devices of various parts.
8. When feeding materials, it is strictly forbidden to put your hands into the feeding hopper for feeding. Can be used to feed inward such as corn stalks.
9. If abnormal noise occurs during operation, stop the machine immediately for inspection, and it is forbidden to troubleshoot the machine while the machine is running.
10. If it is not used for a long time, anti-rust oil should be applied to the non-painted place.