Tire block machine

Tire block cutting machine is prepared for the crush of host machine, Not　only it makes the cutting strip-type waste rubber cut into about 3*8cm　small pieces, but also can enter into host machine again through mutual　use between sword and fixed knife, convenient to feed, high output and　won't damage roller easily, To pay attention to the space between sword　knife and fixed knife when the machine is in operation, best to keep at　around 0. 1mm, so that the steel wire can be cut off. Unique design, high output and long lifetime blade characterize secondary　shredder and fine rubber shredder, which can improve the working efficiency　and lower equipment maintenance cost. Double-grinding pan rubber grinder is featured for low energy consuming　and high output.　Reasonable construction, easy operation and low rate of breakdown.　Environmental-protection, no pollution(no waste gas, no waste residue, no　polluted water), meeting the environmental requirement of the government.

Quran Tire block machine

The tire cutting machine is composed of a motor, a reducer, and a bracket. The bracket is equipped with a side-by-side active roller and a passive roller through the bearing seat. The active roller shaft and the driven roller shaft are meshed with gear teeth with a constant speed ratio to feed the rubber The tire decomposition piece is continuously cut and cut into a long strip with a width equivalent to the thickness of the cutter head. This greatly reduces the repeated cycle cutting and improves the production efficiency.